Tips for using a hole welding machine mainly include the following steps and precautions:
Preparation:
Ensure that the working environment is well ventilated to avoid the accumulation of harmful gases.
Carefully check the integrity of the welding machine housing, power cord and welding cable.
Wear a welding mask, gloves and foot guards to ensure personal protection is in place.
Operation steps:
Place the welding machine in a stable and dry place, away from flammable and explosive items.
Connect a 220-volt household power supply, turn on the switch and lift the cover.
Load the flux-cored wire, straighten it and feed it into the wire feed tube, and then into the wire feeder.
Adjust the wire to expose 2-3 cm, aim the welding gun at the wire and slightly adjust the angle.
Buckle the wire feed wheel and wire feed buckle, and cover the machine cover.
Connect the welding gun switch and ground wire.
Select the Yaoxing welding mode and adjust the appropriate current. Adjust the current to a lower level when welding thin plates and to a higher level for thick plates.
Press and hold the red switch of the welding gun and the machine will start feeding wire.
Adjust the wire to expose 0.5-1 cm, use a wire clamp to fix the welding material, and perform spot welding or pull welding.
Safety Operation Guide:
Follow the rated parameters of the welding machine for welding and avoid overload operation.
Keep the welding cable in good contact with the weldment to prevent the cable from overheating and causing danger.
It is forbidden to perform open-air welding in rainy or humid environments to prevent the risk of electric shock.
After the operation is completed, turn off the power of the welding machine and turn off the power switch.
Clean the work area and properly dispose of welding waste.
Regularly perform professional maintenance on the welding machine to ensure its stable and reliable performance.
